Sun Netra t1 compact flash root

Hardware

To make this work; you need a CF-->laptop IDE (44pin) adapter, and a short ribbon cable.
I had to trim the side-clips off the IDE cable because of the curious mechanism on the netra.

Installation

Boot into OpenBSD install media (I used 4.2, and a miniroot install because it was convenient),
and then realize that it won't work with your CF card(?)--at this point, reboot into the install
media but pass the '-c' flag so that you get into UKC (userconfig).

Once in UKC, it should eyeball kinda like this:

UKC> change wd*
change? y
channel: [-1] (hit enter)
flags: [whatever]: 0xff0
UKC> quit

Now you'll be ready to install. After the installation finishes, you need to pass '-c' again, but
this time it gets waaaaay more stupid.. OpenBoot has no concept of this particular drive, so you need
to boot from a custom devalias:

 boot /pci@1f,0/pci@1/pci@1/ide@e/disk@2:a -c

Follow the same procedure for UKC, and you can later hardcode it in the kernel with config(8).